SNC Clampnut

SNC.GIF

This series of 2 piece CLAMP NUTS has threads specified as COARSE under the Unified system of threads designed unifying the original American National design and the United Kingdom Whitworth design for inch dimensioned threads. This unified system brought about general interchangeability of threads achieved through the standardization of thread form, diameter-pitch combinations and limits of size.

These are the same as the CNC series CLAMP NUTS except that they are split completely into two pieces held together by two socket head cap screws. Benefits are increased holding for equal locking torque; and ease of assembly when shaft of spindle interference at ends.

This model is made of low carbon steel with a black oxide finish and blackened alloy steel socket head cap screws.

As with all precision retaining devices, care must be taken during assembly to assure premium performance. Please open and review our installation instructions for proper technique and best results.



Identification Thread
Outside Dia
(inches)
Face Dia
(inches)
Width
(inches)
Axial Load
(lbs)
Lockscrew
CAD
SNC2-32 8-32 0.625 0.406 0.281 1250 4-40 CAD
SNC3-24 10-24 0.625 0.406 0.281 1450 4-40 CAD
SNC4-20 .250-20 0.625 0.406 0.281 1750 4-40 CAD
SNC5-18 .312-18 0.688 0.469 0.281 2100 4-40 CAD
SNC6-16 .375-16 0.875 0.594 0.344 3200 6-32 CAD
SNC7-14 .437-14 0.938 0.656 0.344 3500 6-32 CAD
SNC8-13 .500-13 1.125 0.781 0.437 5000 10-32 CAD
SNC10-11 .625-11 1.313 0.922 0.437 5900 10-32 CAD
SNC12-10 .750-10 1.500 1.063 0.500 8600 1/4-28 CAD
SNC14-9 .875-9 1.625 1.188 0.500 9500 1/4-28 CAD
SNC16-8 1.000-8 1.750 1.313 0.500 10300 1/4-28 CAD
SNC18-7 1.125-7 1.875 1.438 0.500 11100 1/4-28 CAD
SNC20-7 1.250-7 2.063 1.625 0.500 12100 1/4-28 CAD
SNC22-6 1.375-6 2.250 1.719 0.563 14900 1/4-28 CAD
SNC24-6 1.500-6 2.375 1.844 0.563 15600 1/4-28 CAD

This web page and all information contained 2017, Whittet-Higgins Co.

Whittet-Higgins Home